EasyManuals Logo

Ricoh MP C6502SP System Maintenance

Ricoh MP C6502SP
870 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #832 background imageLoading...
Page #832 background image
34
Module mismatch - Correct
module is not on the SD card
The data on the SD is not correct. Get the correct data
(Japan, Overseas, OEM, etc.) then install again.
35
Module mismatch – Module on
SD card is not for this machine
SD update data is not correct. The data on the SD card is
for a different machine. Get the correct data then install
again.
36
Cannot write module – Cause
other than E34, E35
SD update data is not correct. The data on the SD card is
for a different machine. Get the correct data then install
again.
40 Engine module download failed
Replace the data for the module on the SD card and try
again, or replace the BCU board.
42
Operation panel module
download failed
Replace the data for the module on the SD card and try
again, or replace the LCDC.
43
Stamp data module download
failed
Replace the data for the module on the SD card and try
again, or replace the hard disk.
44
Controller module download
failed
Replace the data for the module on the SD card and tray
again, or replace the controller board.
50
Electronic confirmation check
failed
SD update data is not correct. The data on the SD card is
for a different machine. Get the correct data then install
again.
Updating the LCDC for the Operation Panel
1. Use this procedure to update the LCDC (LCD Control Board).
2.
Turn the copier main switch off.
3. Put the SD card into slot 2.
4. Turn the copier main switch on.
5. Stop until the card utility screen is displayed.
After approximately 10 seconds, the initial screen opens in English.
6. Touch [Opepanel.DOM].
7. Touch [UpDate(#)] to start the update.
While the data downloads, the operation panel goes off.
The LED on the [Start] key flashes red at 1/2 second intervals for approximately 6 minutes.
When the update is completed, the [Start] key starts to flash at 1-second intervals.
8. Turn the copier main power switch off, remove the SD card, then turn the copier on again.
10. Software Version up
830

Other manuals for Ricoh MP C6502SP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh MP C6502SP and is the answer not in the manual?

Ricoh MP C6502SP Specifications

General IconGeneral
BrandRicoh
ModelMP C6502SP
CategoryPrinter
LanguageEnglish

Related product manuals