EasyManuals Logo

Ricoh MP C6502SP System Maintenance

Ricoh MP C6502SP
870 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #831 background imageLoading...
Page #831 background image
Errors During Firmware Update
If an error occurs during a download, an error message will appear. The error code consists of the letter
"E" and a number ("E20", for example).
Error Message Table
No. meaning Solution
20 Cannot map logical address
Make sure the SD card is installed correctly, or use a
different SD card.
21 Cannot access memory HDD connection not correct, or replace hard disk.
22
Cannot decompress compressed
data
The ROM data on the SD card is not correct, or data is
damaged.
23
Error occurred when ROM update
program started
Controller program defective. If the second attempt fails,
replace the controller board.
24 SD card access error
Make sure the SD card is installed correctly, or use a
different SD card.
30
No HDD available for stamp data
download
HDD connection not correct or replace hard disks.
31
Data incorrect for continuous
download
Install the SD card with the remaining data necessary for
the download, then re-start the procedure.
32
Data incorrect after download
interrupted
Do the recovery procedure for the module, then repeat
the installation procedure.
33 Incorrect SD card version
The ROM data on the SD card is not correct, or data is
damaged.
Software Update
829

Other manuals for Ricoh MP C6502SP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ricoh MP C6502SP and is the answer not in the manual?

Ricoh MP C6502SP Specifications

General IconGeneral
BrandRicoh
ModelMP C6502SP
CategoryPrinter
LanguageEnglish

Related product manuals