8-13 mm (0.3-0.5 in.)
20 mm (0.8 in.)
CNT009
Cause:
A shock jitter occurs when the trailing edge of the paper leaves the paper guide during paper transfer
and causes toner scattering.
This may occur if paper with a thickness equivalent to Paper Weight 4 or higher is used.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
• Changing the transfer current may produce either or both of the following side effects:
• Reduction in toner yields
• Occurrence of banding (streaks)
Solution:
1. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use,
select 1202: [Image Transfer Output].
2. Check the present value. Is it lower than 100 A?
Yes Carry out all of the following:
(1) Increase the value by 5 A in 1202: [Image Transfer Output].
(2) Set [Trailing Edge] of 1204: [Paper Transfer Output Correction: Paper Edge] to
"200%".
(3) Set [Trailing Edge Length] of 1204: [Paper Transfer Output Correction: Paper Edge] to
"30 mm".
No No further improvement is likely. Contact your service representative.
Toner Scatter
35
To Next Page
Loading...
