Color Loss
White Spots
White spots of 0.2–0.3 mm (0.008–0.01 inches) in diameter appear.
Cause:
This may occur if printed at low temperature or humidity.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
• If you reduce the paper transfer current to eliminate white spots, copies may become too faint.
Solution:
The solution depends on which side of the paper the problem occurs on.
• If the problem occurs on side 1 of the paper, perform the solution described in (a).
• If the problem occurs on side 2 of the paper, perform the solution described in (b).
• If the problem occurs on both sides, perform the solutions described in (a), and then (b).
(a) If the problem occurs on side 1
1. Adjust the setting for the side 1 of the paper. Select [Machine: Image Quality] in
[Advanced Settings] for the custom paper in use, decrease the absolute value of [Side 1]
by 5 A in 1203: [Paper Transfer Output].
Example: If the present current is −100 A, change it to −95 A.
Color Loss
37
To Next Page
Loading...
