No. Item Description
73 [Txt Ppr: Ppr Trns Isolatn
Voltag: Side 2]
Adjust the separation voltage for secondary transfer
applied to Side 2 when Textured Paper mode is enabled.
Fuser Adjustment
For details about the following items, see page 105 "Fuser Adjustment".
No. Item Description
74 [Fusing Heat Roller
Temperature Adj]
Adjust the heat roller temperature.
75 [Fusing Pressure Roller
Temperature Adj]
Adjust the pressure roller temperature.
76 [Fusing Nip Width Setting] Adjust the nip width between the fusing belt and pressure
roller.
77 [Adjust Fusing Temprtr to
Transfer Paper]
Adjust the fusing temperature at which to allow paper
feeding after warming up.
78 [Adjust Adding Fusing
Temperature 1]
Adjust the fusing unit's accumulated temperature for a
specific time after a job starts.
79 [Adjust Adding Fusing
Temperature 2]
Adjust the fusing unit's accumulated temperature for a
specific time after writing starts.
80 [Paper Feed Interval
Setting]
Adjust the interval between the feeding of each sheet.
81 [Reduce Initial CPM: Low
Temp. Envrnmt.]
Select one of the three levels of copy/print speed
reduction at low temperatures.
82 [Reduce Initl CPM:
Norml/High Temp Env]
Select one of the three levels of copy/print speed
reduction at normal room temperature and above.
83 [Adjust Cleaning Web
Motor Interval]
Specify the interval between each activation of the
cleaning web.
84 [Cleaning Web Contact
and Disengage]
Specify how the cleaning web comes into contact and
separates.
85 [Fusing Nip Width Adj. for
Envelope]
Adjust the nip width between the fusing belt and pressure
roller when an envelope is being fed.
Menu Items and Functions
77
To Next Page
Loading...
