Setting Items Max. Value Min. Value Step Unit
[Switchback Exit Feed Speed Adj: CCW] 3.0 -3.0 0.1 %
28: [2 sdd Swtchbk Mtr Feed Spd Adj: CCW]
Adjust the 2-sided switchback motor's speed (counterclockwise rotation).
2-Sided Switchback Motor (switchback motor for duplex printing) drives the rollers that turn the paper
over and feed it to the horizontal duplex paper transfer unit for duplex printing.
Press [+] to increase the speed and [−] to reduce it.
Enter the same values that are specified for the switchback drive (25 and 26).
Setting Items Max. Value Min. Value Step Unit
[2 sided Switchback Motor Feed Speed
Adj: CCW]
3.0 -3.0 0.1 %
29: [2 sided Exit Motor Feed Speed Adj]
Adjust the 2-sided exit motor's speed.
Two-Sided Exit Motor (exit motor for duplex printing) drives the rollers at the exit of the horizontal
duplex paper transfer unit.
Press [+] to increase the speed and [−] to reduce it.
Enter the same values that are specified for 16: [Registration Motor Feed Speed Adj].
Setting Items Max. Value Min. Value Step Unit
[2 sided Exit Motor Feed Speed Adj] 3.0 -3.0 0.1 %
30: [2 sided Transport Roller Shift Adj 1]
Adjust the roller's shift amounts produced by Shift System 1in the horizontal duplex paper transfer unit
for duplex printing.
Press [+] to increase the degree of shift and [−] to reduce it.
• The machine adjusts the vertical position of Side 2 (relative to the main scanning direction) by the
shifting movement of the horizontal duplex paper transfer unit for duplex printing. When paper with
a feed length of 220 mm (8.66 inches) or less is used, only Shift System 2 can be used. When
Setting Values
91
To Next Page
Loading...
