Ricoh Pro C5110S - Page 308

003
Function Flag *CTL
[0 or 1 / 0 / 1/step]
0: Disabled, 1: Enabled
Enables or disables the remote service function.
004 Commnication Test Call CTL
[- / - / -]
[Execute]
005 Device Information Call CTL
[- / - / -]
[Execute]
007
SSL Disable *CTL
[0 or 1 / 0 / 1/step]
0: No. SSL used.
1: Yes. SSL not used.
Controls if RCG (Remote Communication Gate) confirmation is done by SSL during an
RCG send for the @Remote over a network interface.
008
RCG Connect Timeout *CTL [1 to 90 / 30 / 1second/step]
Sets the length of time (seconds) for the time-out when the RCG (Remote Communication
Gate) connects during a call via the @Remote network.
009
RCG Write Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the time-out when sent data is written to the RCG
during a call over the @Remote network.
010
RCG Read Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the timeout when sent data is written from the RCG
during a call over the @Remote network.
011
Port 80 Enable *CTL
[0 or 1 / 0 / 1/step]
0: No. Access denied
1: Yes. Access granted.
Controls if permission is given to get access to the SOAP method over Port 80 on the
@Remote network.
012
@Remote Commnuication
Rermission Setting
*CTL
[0 to 2 / 1 / 1/step]
0: Disabled
1: Enabled
2: Limited
3. Main SP Tables-5
306