Ricoh Pro C5110S - Page 55

010
Abp[1] Lwr Threshold *ENG
[0.000 to 0.100 / 0.005 /
0.001mg/cm2/step]
Sets Abp[1] Lower Threshold for OPC Cycle of Development Bias.
011
Abd[1] Lwr Threshold *ENG
[0.000 to 0.100 / 0.005 /
0.001mg/cm2/step]
Sets Abd[1] Lower Threshold for Development Roller Cycle of Development Bias.
020
deltaP_Upp Threshold *ENG [0.0 to 180.0 / 60.0 / 0.1deg/step]
Sets the deltaP_Upp Threshold per rotating body rotation of Adhesion amount patch.
3671 [Vc:Coef:Setting]
001
Scp[1] *ENG [0.00 to 2.55 / 1.00 / 0.01/step]
Sets Frequency Correction Coefficient Scp[1] for OPC Cycle amplitude of Vc.
011
Kcp1 *ENG [0.00 to 2.55 / 1.00 / 0.01/step]
Sets Line Speed: Mid Correction Coefficient Kcp1 for OPC Cycle amplitude of Vc.
012
Kcp2 *ENG [0.00 to 2.55 / 0.90 / 0.01/step]
Sets Line Speed: Low Correction Coefficient Kcp2 for OPC Cycle amplitude of Vc.
051
Scd[1] *ENG [0.00 to 2.55 / 1.10 / 0.01/step]
Sets Frequency Correction Coefficient Scd[1] for Development Roller Cycle amplitude of
Vc.
061
Kcd1 *ENG [0.00 to 2.55 / 1.00 / 0.01/step]
Sets Line Speed: Mid Correction Coefficient Kcd1 for Development Roller Cycle amplitude
of Vc.
062
Kcd2 *ENG [0.00 to 2.55 / 0.90 / 0.01/step]
Sets Line Speed: Low Correction Coefficient Kcd2 for Development Roller Cycle amplitude
of Vc.
071
tadj_c:K *ENG
[-0.500 to 0.500 / 0.000 / 0.001s/
step]
Sets tadj_c (K) time for Vc (K).
SP3-XXX (Process)
53