Ricoh Pro C5110S - Page 769

010
Feed Mtr 2:Feed Speed2:Mid
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
011
Feed Mtr 2:Feed Speed2:Mid-
Low Speed *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
012
Feed Mtr 2:Feed Speed2:Low
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
013
Feed Mtr 2:Feed Speed2:Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
014
Feed Mtr 2:Feed Speed2:Mid
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
015
Feed Mtr 2:Feed Speed2:Mid-
Low Speed *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
016
Feed Mtr 2:Feed Speed2:Low
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
017
Feed Mtr 3:Feed Speed3:Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
Output Check Table
767