Ricoh Pro C5110S - Page 771

026
Feed Mtr 4:Feed Speed4:Mid
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
027
Feed Mtr 4:Feed Speed4:Mid-
Low Speed *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
028
Feed Mtr 4:Feed Speed4:Low
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
029
Feed Mtr 4:Feed Speed2:Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
030
Feed Mtr 4:Feed Speed2:Mid
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
031
Feed Mtr 4:Feed Speed2:Mid-
Low Speed *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
032
Feed Mtr 4:Feed Speed2:Low
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
033
Transport Mtr1:Feed Speed1:Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
Output Check Table
769