Ricoh Pro C5110S - Page 777

074
Relay Mtr:CCW:Feed
Speed1:Mid Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
075
Relay Mtr:CCW:Feed
Speed1:Mid-Low Speed *D136
only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
076
Relay Mtr:CCW:Feed
Speed1:Low Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
077
Relay Mtr:CCW:Feed Speed2:Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
078
Relay Mtr:CCW:Feed
Speed2:Mid Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
079
Relay Mtr:CCW:Feed
Speed2:Mid-Low Speed *D136
only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
080
Relay Mtr:CCW:Feed
Speed2:Low Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
081
Relay Mtr:Position Hold Stop ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
Output Check Table
775