• The approximate time it takes to transfer the debug log is as follows. Transfer time may be
affected by the type or format of the SD card. (It is recommended that you format the SD card
using the Panasonic SD Formatter (freeware)).
•
Controller debug log (GW debug log): 2 - 20 minutes
• Engine debug log: 2 minutes
• Operation panel debug log: 2 - 20 minutes
6. Make sure that the SD card access LED is off, then remove the SD card.
• If ‘failed’ appears on the touch panel display, turn the power off, and then recover from step
1 again.
The debug logs are saved with the following file names.
Controller debug log (GW debug
log)
/LogTrace/machine number/watching/
yyyymmdd_hhmmss_unique identification number.gz
Engine debug log
/LogTrace/machine number/engine/
yyyymmdd_hhmmss.gz
Operation panel debug log
/LogTrace/machine number/opepanel/
yyyymmdd_hhmmss.tar.gz
13. Capturing Log to SD card
866
To Next Page
Loading...
