Ricoh Pro C5200 Series - Fuser Adjustment

CIP Training Pro C5200 series
Adjustment Settings for Operators
Setting Items Max. Value Min. Value Step Unit
[Textured Paper Mode Voltage: FC: Side
1]
14.0 0.0 0.1 KV
036: [Textured Paper Mode Voltage: FC: Side 2]
Adjust the paper transfer voltage applied to Side 1 when printing in full color with Textured Paper mode
enabled.
Jk^llU%Wmhbg\k^Zl^ma^ohemZ`^Zg]UƽWmhk^]n\^bm(
Setting Items Max. Value Min. Value Step Unit
[Textured Paper Mode Voltage: FC: Side
2]
14.0 0.0 0.1 KV
Fuser Adjustment
050: [Fusing Temp]
Adjust the heat roller temperature.
Jk^llU%Wmhbg\k^Zl^ma^m^fi^kZmnk^Zg]UƽWmhk^]n\^bm(
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper (cold
offset).
• Increasing the temperature too much may distort the paper and cause glossy lines, paper jams,
and insufficient toner fusing (hot offset).
• Depending on the type of paper, you can increase the toner gloss by increasing the temperature
by 5 to 10°C over the initial factory setting.
Setting Items Max. Value Min. Value Step Unit
[Fusing Temp] 200 100 1 degree(s)
051: [Fusing Pressure Roller Temp]
Adjust the pressure roller temperature.
Jk^llU%Wmhbg\k^Zl^ma^m^fi^kZmnk^Zg]UƽWmhk^]n\^bm(