Ricoh Pro C5200 Series - Page 130

CIP Training Pro C5200 series
Adjustment Settings for Operators
If set to [On], the cleaning web separates during printing. If paper jams or the fusing pressure roller
rotates in reverse, the cleaning web automatically separates regardless of this setting.
This must be adjusted if image quality degradation due to fusing (black spots) occurs when printing on
glossy or matte paper.
• When using paper smaller than A3 (11 × 17 inches), the cleaning web separates regardless of this
setting.
Setting Items Values
[Cleaning Web Contact Position] [On]
[Off]
058: [Fusing Nip Width Adjustment: Envelope]
Adjust the nip width between the fusing belt and pressure roller when an envelope is being fed. If the
^go^ehi^[^\hf^lpkbgde^]&ik^llUƽWmhk^]n\^ma^gbipb]ma(C_Z_nlbg`^kkhk]^o^ehilhgma^
envelope, press [+] to increase the nip width. Increasing the nip width too much may cause the envelope
to become wrinkled.
Setting Items Max. Value Min. Value Step Unit
[Fusing Nip Width Adjustment: Envelope] 20000 0 1 Micromete
r
100: [Paper Feed Interval Setting]
Adjust the interval between the feeding of each sheet.
The standard interval is "100". If you set this to "50", the throughput will be reduced in half.
Jk^llU%Wmhbg\k^Zl^ma^bgm^koZeZg]UƽWmhk^]n\^bm(
• Depending on the fusing unit's temperature and the size of paper, if you increase the interval by
ik^llbg`UƽW&ma^\hir)ikbgmli^^]fZr]^\k^Zl^(
Setting Items Max. Value Min. Value Step Unit
[Paper Feed Interval Setting] 100 1 1 %