• [FC/FCS]
[Leading Edge]
• [S]
[Leading Edge: Clear/Sp], [Leading Edge: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even if the value is decreased to the
lower limit, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
Fainter Trailing Edge
The trailing edge is fainter.
Cause:
This may occur because of insufficient or excessive paper transfer current when using paper weighing
approximately 160 g/m
2
(60 lb. Cover) or heavier at low temperature or humidity.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Unprinted
109
To Next Page
Loading...
