(b) Adjusting the target constant voltage (Insufficient transfer current)
1. In [Advanced Settings] for the custom paper you are using, select 1216: [Paper Transfer
Output Correction: Paper Edge], and then increase the value in the following
corresponding settings by "1".
• [BW]
[Leading Edge]
• [FC/FCS]
[Leading Edge]
• [S]
[Leading Edge: Clear/Sp], [Leading Edge: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even if the value is increased to the
upper limit, go to the next step.
3. Select 1216: [Paper Transfer Output Correction: Paper Edge], and then increase the value
in the following corresponding settings by "5 mm".
• [BW]
[Leading Edge Length]
• [FC/FCS]
[Leading Edge Length]
• [S]
[Leading Edge Len.: Clr/Sp], [Leading Edge Len.: White]
4. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 3 and 4. If the problem persists even if the value is increased to the
upper limit, contact your service representative.
(c) Adjusting the target constant voltage (Insufficient/excessive transfer current)"
1. In [Advanced Settings] for the custom paper you are using, select 1216: [Paper Transfer
Output Correction: Paper Edge], and then decrease the value in the following
corresponding settings by "1".
• [BW]
[Leading Edge]
7. Image Quality Problem: Full Page
108
To Next Page
Loading...
