5. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
6. Has the image quality improved?
If uncertain, set the prior value of 1214: [Paper Transfer Output] to "-5", and then confirm the
image quality.
Yes Go to the next step.
No Repeat Steps 4 to 6.
7. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(b) Executing the toner refreshing".
If the density of spotting does not change after adjusting the image transfer and
paper transfer outputs, contact your service representative.
(b) Executing the toner refreshing
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
select 0506: [Execute Developer Refreshing], and then execute [Black].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(c) Adjusting the maximum image density".
(c) Adjusting the maximum image density
1. In [Advanced Settings] for the custom paper you are using, select 1201: [Max Image
Density], and then increase the value in [Black] by 2.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Select 1201: [Max Image Density], and then increase the value in [Black] by 4.
7. Image Quality Problem: Full Page
126
To Next Page
Loading...
