• When printing small solid fill images.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Adjusting the image transfer output
1. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then increase the values in [Cyan], [Magenta], and [Yellow] in [FC/FCS] by
1.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Has the image quality improved?
If uncertain, set the prior value of 1212: [Image Transfer Output] to "+5", and then confirm the
image quality.
Yes Repeat steps 1 through 3. If no improvement is observed, keep the settings which
gave the best results, and proceed to "(b) Executing the toner refreshing".
No Reset the value in 1212: [Image Transfer Output], and then contact your service
representative.
(b) Executing the toner refreshing
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
select 0506: [Execute Developer Refreshing], and then execute [KCMY].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Uneven Density: 189 mm (7.5 inches) Pitch
Density fluctuation occurs at intervals of 189 mm (7.5 inches).
7. Image Quality Problem: Full Page
128
To Next Page
Loading...
