189 mm (7.5 in.) 189 mm (7.5 in.)
CNT002
Cause:
If the machine is left unattended for a long period in an environment where temperature and humidity
are high, corona products on the photoconductor unit absorb moisture to prevent a buildup or removal
of static electricity on the photoconductor unit.
Solution:
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
execute 0501: [Execute Process Adjustment].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Execute 0501: [Execute Process Adjustment].
3. Repeat step 2. If the problem persists even though you have repeated Step 2 five times or
more, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
Uneven Density within 90 mm (3.5 inches) of the Trailing Edge
Printing in the area extending approximately 90 mm (3.5 inches) from the trailing edge is fainter or
denser.
Uneven Density
129
To Next Page
Loading...
