Ricoh PRO C7200X

Procedure (a):
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
select 0508: [Manually Smooth Fusing Belt] and execute [Uneven Gloss: Short Time].
2. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Execute [Uneven Gloss: Short Time] in 0508: [Manually Smooth Fusing Belt] until
the problem is resolved.
3. Register the paper in the custom paper profile.
4. To prevent this problem, polish the fusing belt by the fusing belt smoothing roller more
frequently. In [Advanced Settings] for the custom paper you are using, select 1243:
[Fusing Belt Smoothing], and then set the value in [For Uneven Gloss (Short Time)] to
[Most Frequently].
5. Print the image. Did glossy, horizontal lines appear?
Yes Proceed to "Procedure (b)"
No Finished!
Procedure (b):
1. Adjust the paper feed interval. This will decrease the throughput, but is it OK?
Yes Go to the next step.
No No further improvement is likely. Contact your service representative.
2. In [Advanced Settings] for the custom paper you are using, select 1237: [Print Speed
(Sheet Interval Adj)], and then decrease the value in the following corresponding settings
by 20%.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
3. Print 50 or more A3 sheets. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3. If the problem persists, contact your service representative.
Uneven Density
157