Ricoh PRO C7200X

[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Select 1241: [Fusing Nip Width Adjustment], and then set [Other than Envelope] to 3.
3. Select 1244: [Fusing Pressure Roller On Before Fusing] to [On].
4. Print 20 or more A4 sheets.
5. Is the toner fusibility within the permissible range?
Yes Go to the next step.
No Proceed to "(c) Adjusting the printing speed".
6. Has the problem been resolved?
Yes Finished!
No Carry out "(a) Decrease the fusing temperature".
If the problem persists, proceed to "(d) Decreasing the fusing nip width 2".
(c) Adjusting the printing speed
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then check the present value in the following corresponding settings.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
Others
207