Solution:
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then increase the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Repeat Steps 1 and 2.
If the problem persists even if you increase the value to 200°C, contact your service
representative.
3. Is the paper curled?
Yes Go to the next step.
No Finished!
4. In [Advanced Settings] for the custom paper you are using, select 1321: [Correct Paper
Curl], and then adjust the degree of decurling.
To correct curls facing up, specify "U Curl Correction Level".
To correct curls facing down, specify "П Curl Correction Level".
5. Print the image. Has the problem been resolved?
Yes Go to the next step.
Paper Feed Problems Affecting Image Quality
241
To Next Page
Loading...
