No Repeat Steps 3 to 5
If the problem persists, contact your service representative.
Horizontal Folding and Wrinkles: Thin Coated Papers
When printed on thin coated paper, horizontal folds and wrinkles occur on the paper.
Cause:
When printing on thin coated papers, a difference in speed between the fusing roller and the buffer
roller of the buffer pass unit can lead to horizontal folds or wrinkles.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Adjusting the motor speed
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then set [Cooling Roller After Fusing] to -0.6%.
2. Select 1341: [Motor Speed], and then set [Paper Output: Diversion Roller] to -0.2%.
3. Print 10 or more A3 sheets.
4. Are there horizontal folds?
Yes Select 1341: [Motor Speed] and increase the values in [Cooling Roller After
Fusing] and [Paper Output: Diversion Roller] by 0.1%, and then repeat Steps 3 and
4.
8. Troubleshooting Paper Delivery Problems
242
To Next Page
Loading...
