Taurus-C1 Training
277
Slide 277
Laser Unit: After Installing a New One
After the laser unit is replaced, an SP code must be
executed.
SP2108-1: Image Parameter - K/C Writing Unit
SP2108-2: Image Parameter - Y/M Writing Unit
These SP codes automatically set the operation
parameters for the laser unit (main scan registration, main
scan magnification, shading, and bow skew adjustment).
It is not necessary to input values from a printed sheet of
paper.
Never open a front door or switch the machine off while
these SP code settings are in progress.
If an SC error code is returned, switch the power off and do
these SP codes again.
No additional notes
To Next Page
