Taurus-C1 Training
56
Slide 56
Components used during Process Control
 This machine has three ITB sensors (see above). Only the
middle sensor functions as an ID sensor, but all three
sensors are active MUSIC sensors.
 Two temperature/humidity sensors are used during
process control.
 One is located on the left, below the used toner bottle
motor. The other is on the right near the K_PCDU.
D016 series
Taurus-C1/P1
 The number of sensors in the ITB sensor array has been reduced. The D016, for
example, had seven sensors as shown above: three MUSIC sensors and four ID
sensors.
 Temperature/humidity sensors: In previous machines, the left sensor was higher
and near the Y_PCDU.
To Next Page
Loading...
