Ricoh SP 150w - Page 60

No. Item Details Values
5 Destination Code
Specify the area where the machine
is sold and used.
This setting is important. It
determines the following:
• Default paper size. LT for NA,
and A4 for all other areas.
• Units of measure: inches for NA,
and millimeters for all other areas.
• Fixed steps for reduction/
enlargement.
Normally, do not change the
destination code. After replacing the
main board, return the destination
code to its original value.
0 to 255
6 SC 559 Detection
SC 559 is the error code for Fusing
Unit Third Jam Error (Fatal Error).
Specify whether to enable SC 559
detection.
0: Off
1: On
7 Plate Control Mode
Specify whether to use the plate
control mode.
0: On
2: Off
8 Low Humidity Mode
Black lines a few millimeters thick
may appear on prints when the
machine is operated in a low
humidity environment. Enabling this
mode may help to solve the
problem.
0: Off
1: On
9 Primary Cooling Mode
Specify whether to use the primary
cooling mode.
0: Off
1: On
10 Serial No.
The serial number of the machine is
displayed.
Normally, do not change the serial
number. After replacing the main
board, return the serial number to its
original value.
-
4. System Maintenance
58