6.Troubleshooting
197
setting of the fusing temperature in SP).
Set the Paper type to one level thinner than the paper now being used (e.g., change "Normal" to
"Thin").
Wrinkles appear When Using Limp Paper
The wrinkles may occur in the ejected paper.
Set the [Paper Buckle Amount] in the SP menu to between [-3] and [-8] and set the appropriate value
while checking the status of the wrinkles and the skew.
Four-line LCD panel: SP menu > [Engine Maintenance] > [Paper Buckle Amount]
Touch panel: SP menu > [Engine Service Setting] > [Paper Buckle Amount]
Low Image Density on Solid Images
Problem
Low image density may occur after 81 mm from the leading edge of a solid image.
Causes
Toner unevenness on the development roller occurs because not enough toner is provided to the
To Next Page
Loading...
