What to do if the staple tray entrance sensor does not turn off on Ricoh SR790 Finishers?
If the staple tray entrance sensor on your Ricoh Finishers doesn't turn off in the expected time after activation, the suggested solution is to check the wiring to the staple tray entrance sensor.
What to do if the tray exit sensor does not turn off within the normal time on Ricoh SR790?
If the tray exit sensor does not turn off within the normal time after turning on in Ricoh Finishers, examine the tray exit sensor for errors.
What to do if the entrance sensor does not turn off within the normal time on Ricoh SR790 Finishers?
If the entrance sensor does not turn off within the normal time after it turns on for Ricoh Finishers, inspect the entrance sensor for any obstructions.
What to do if the lower exit sensor turns on when the feed-out pawl returns on Ricoh Finishers?
If the lower exit sensor turns on when the feed-out pawl returns to its home position after feeding out the outputs on Ricoh Finishers, you should review the timing of the feed-out pawl's return.
What to do if the entrance sensor does not turn on within the normal time on Ricoh SR790?
If the entrance sensor does not turn on within the normal time after the main machine exit sensor turns on for Ricoh Finishers, check the entrance sensor connections.
What to do if the stapler tray entrance sensor does not switch on Ricoh Finishers?
If the stapler tray entrance sensor does not switch on within the normal time after the entrance sensor switched on Ricoh Finishers, test the stapler tray entrance sensor.
What to do if the lower tray exit sensor does not turn on Ricoh SR790 Finishers?
If the lower tray exit sensor does not turn on within the normal time after the entrance sensor turns off on Ricoh Finishers, verify the lower tray exit sensor functionality.
What to do if the lower exit sensor does not turn on after the feed-out pawl feeds out the outputs on Ricoh Finishers?
If the lower exit sensor does not turn on after the feed-out pawl feeds out the outputs on Ricoh Finishers, inspect the feed-out pawl and lower exit sensor.
Procedures for replacing and adjusting the Main PCB, including necessary components.
Details on replacing the shift motor, including rear cover removal.
Procedures for replacing the stapler motor, referencing rear cover removal.
Instructions for replacing upper transport and exit motors.
Procedures for replacing the lower transport motor, referencing Main PCB.
Details on replacing the stack height sensor assembly and sensor.
Procedure for replacing the stapler tray paper sensor.
Table detailing jam detection scenarios for shift and staple modes based on sensor status.
General| Type | Finisher |
|---|---|
| Function | Stapling |
| Paper Weight | 52 to 300 gsm |
| Output Tray Capacity | 500 sheets |
| Staple Positions | 2 Staples |
| Sheet Capacity | 50 sheets |
To Next Page
