Need help?Do you have a question about the Ricoh SR3300 and is the answer not in the manual?
Meaning of symbols and abbreviations used in the manual.
List of registered trademarks and trademarks mentioned in the manual.
Details about modifications compared to the previous machine model.
Technical specifications of the internal finisher, including paper size and weight.
Diagrams and labels identifying the various parts of the finisher.
Explanation of how the finisher detects when the paper exit tray is full.
Describes the paper path and shifting mechanism for paper exit.
Details on how the shift motor operates to move paper side-to-side.
Mechanism for releasing pressure on paper exit rollers and belts.
Mechanism for ejecting stapled paper and paper alignment.
Mechanism of the junction gate and trailing edge presser.
How the paper exit sensor detects paper on the stack guide plate.
Mechanism for aligning paper edges in the main-scan direction.
Details on the crimping method and stapling operations.
Explanation of single and double stapling modes.
Mechanism for moving the stapler unit for stapling operations.
Step-by-step guide to removing the entire internal finisher unit.
Procedures for removing and replacing the stapler unit.
Procedures for removing exterior covers and the paper exit tray.
Steps to remove the finisher front cover.
Steps to remove the finisher upper cover.
Procedure for removing the rear cover of the finisher.
Procedure for removing the paper exit cover.
Procedure for removing the paper exit tray.
Information on various sensors and switches within the finisher.
Steps to remove and replace the entrance sensor.
Steps to remove and replace the sub-scan registration sensor.
Steps to remove and replace the door switch.
Steps to remove and replace the shift HP sensor.
Steps to remove and replace the paper exit sensor.
Steps to remove and replace the paper exit pressure HP sensor.
Steps to remove and replace the junction gate motor HP sensor.
Steps to remove paper exit full sensors 1 and 2.
Steps to remove and replace the stapler drive HP sensor.
Procedures for removing and replacing various motors.
Steps to remove and replace the shift motor (STM3).
Steps to remove and replace the transport motor (STM2).
Steps to remove and replace the junction gate motor (STM1).
Steps to remove and replace the paper exit pressure motor (STM4).
Steps to remove and replace the stapler drive motor (DCM1).
Procedures for removing and replacing the controller board.
Steps to remove and replace the controller board (PCB1).
To Next Page
General
