Need help?Do you have a question about the Ricoh SR4110 and is the answer not in the manual?
Detailed descriptions of the finisher's mechanisms, including components and layout.
A list of fuses used in the finisher, their capacity, voltage, and affected parts.
Visual representation of the finisher's components and their numbering.
Diagram and list of electrical components within the finisher.
Overview of the drive system and its components.
In-depth explanations of specific mechanical systems and their functions.
Explanation of the inverter mechanism for paper path control.
Details on the shift tray's operation, movement, and sensors.
Description of the pre-stack mechanism for paper handling and feeding.
Explanation of the jogger mechanism for aligning paper stacks on the staple tray.
Information about the stapling process, staple trimming, and related components.
Details on the punch unit for creating holes in paper, including 3-hole punching.
Methods and sensors used for detecting paper jams in the finisher.
Configuration settings via DIP switches for various operational modes and testing.
Instructions for removing and replacing various external covers of the finisher.
Procedure for removing and replacing the jogger unit cover.
Steps for replacing drag roller, positioning roller, and alignment brush roller.
Instructions for removing and replacing the left and right jogger fences.
Procedures for replacing various sensors including paper height, exit guide, and tray sensors.
Detailed steps for removing and installing a new stapler unit.
Procedures for replacing shift tray exit motor and shift tray lift motor.
Steps to replace drag roller, drag drive motors, and drag drive HP sensor.
Procedures for replacing the shift motor and associated sensors.
Steps to replace the jogger top fence motor.
Procedures for removing and replacing the jogger unit.
Instructions for replacing the jogger bottom fence motor.
Details on punch unit adjustment and procedures for replacing punch unit components.
General procedures for replacing various motors in the finisher.
Procedures for replacing upper/lower transport motors and exit guide motor.
Procedures for replacing upper tray exit and junction gate motors.
Procedures for replacing pre-stack transport, junction gate, and stopper motors.
Procedure for removing and replacing the punch motor.
Procedures for replacing stapler junction gate and exit motors.
Configuration settings using DIP switches for various operational modes and testing.
Locations and purpose of test points for sensor testing and shipping position.
List of fuses and their protective functions within the finisher.
To Next Page
General
