32DSSS01.A
2-
1. ENTERING VEHICLE
NOTE: The occupant restraint belt must be fastened to enable the STOW/DEPLOY and
UP/DOWN functions. The lift will not operate unless this safety mechanism is
properly engaged.
a. DEPLOY PLATFORM - Push and hold DEPLOY switch until platform completely
unfolds from vehicle and stops at floor level.
b. LOWER PLATFORM - DO NOT STAND on inboard rollstop as platform lowers.
Push and hold DOWN switch until lift contacts ground and rollstop opens
completely.
1) Unfasten occupant restraint belt, carefully place
wheelchair centrally on platform, facing outward,
and LOCK WHEELCHAIR BRAKES.
2) Be certain wheelchair is safely within platform pe-
rimeter and does not interfere with operation of
platform rollstop.
3) STANDEES should stand in center of platform fac-
ing direction of travel (toward vehicle).
4) FASTEN OCCUPANT RESTRAINT BELT.
c. RAISE PLATFORM - Push and hold UP switch until platform raises and stops
automatically at vehicle floor level.
♦ Release wheelchair brakes, carefully board passenger into vehicle, and
secure wheelchair.
d. REFER TO “STOWING PLATFORM” SECTION BELOW TO STOW PLATFORM.
2. EXITING VEHICLE
NOTE: The occupant restraint belt must be fastened to enable the STOW/DEPLOY and
UP/DOWN functions. The lift will not operate unless this safety mechanism is
properly engaged.
a. DEPLOY PLATFORM - Push and hold DEPLOY switch until platform completely
unfolds from vehicle and stops at vehicle floor level.
1) Be certain platform is safely at vehicle floor level and platform rollstop is in
an up and locked position.
2) FASTEN OCCUPANT RESTRAINT BELT.
3) Carefully place wheelchair centrally on
platform, facing outward away from ve-
hicle, and LOCK WHEELCHAIR BRAKES.
4) STANDEES should stand in center of
platform facing direction of travel (away
from vehicle).
To Next Page
Loading...
Need help?
General
