Technical information
Maintenance
2
Ridder Drive Systems B.V. T +31 (0)341 416 854 I ridder.com E info@ridder.com
6
Maintenance RB tube motors
Inspection and maintenance work is only permitted to approved personnel.
Maintenance RB
For the Ridder RB tube motor and accessories not much maintenance is necessary. It is recommended
to do the checks that follow every 6 months.
● Do a check of the set end positions of the limit-switch system.
Are they still correct for the system?
Can the tube motor turn freely? Because of folds the roller screen winds up faster!
● Do a check of the operation of the guiding unit on the guiding profile. A dirty guiding profile can
cause irregular operation (thus uses more power).
● Do a check for a correctly tightened head of the tube motor.
● Do a check for a not damaged power cable of the tube motor.
Maintenance RPR drive-units
Inspection and maintenance work is only permitted to approved personnel.
Maintenance RPR
Maintenance on the RPR drive-unit is usually not necessary ("maintenance-free"). It is recommended
to do the checks that follow every 6 months:
● Of the correct operation of the drive unit and the system
● For oil leakage. Tell your installer if there is a leakage
● Of the mechanical condition (wear and tear, output-shaft connections to the operated system,
fasteners, correctly attached and such)
● Of the adjusted end positions (are they still correct for the system?).
To Next Page
Loading...
