RIDGID 1450 - Product Information; Product Description; Technical Specifications; Operating Instructions

1450 Pressure Testing Pump
Ridge Tool Company 3
Description, Technical
Information, Standard
Equipment and Accessories
Description
The RIDGID Model 1450 pressure testing pump is de-
signed to pressure test all types of fluid systems for leaks
including heating, compressed air, oil, fire sprinkler, and
small bore pipeline systems. The Model 1450 uses a
variable lever-arm design and automatic pressure holding
valves to enable the user to easily pressurize the system.
NOTE! Test pressures can be achieved very easily with the
Model 1450. Use caution when pressurizing the
system by watching the pump's pressure gauge
closely. Pressurizing systems above the pump's
rated pressure of 50 Bar/725 psi can cause damage
to the pump's components.
Specifications
Type: .............................Ridgid No. 1450
L/W/H ............................28/8.5/9.5 inches
Weight ...........................14 lbs.
Max. Pressure ...............50 Bar/725 psi
Piston Vol ......................2.3 in
3
Outlet Hose
Connection ....................
1
/
2
″ BSPP or
1
/
2
″ NPT
Reservoir Capacity........3.6 gallons
Liquid ............................Water
Oil
Ethylene Glycol
Max. Temp. ...................120°F (50°C)
Operating the 1450 Pressure
Testing Pump
1. Completely fill piping system with liquid.
2. Ensure pump has sufficient liquid in reservoir to cover
inlet suction hose. (Figure 1)
3. Close pressure relief valve. (Figure 2)
4. Connect outlet hose to piping system.
Figure 1
Inlet Suction
Hose
Figure 2