To Next Page
T
Tamara WilcoxAug 14, 2025
How to fix a RIDGID Sander that won't turn on?
- NNicole BatesAug 14, 2025
If your RIDGID Sander's motor will not run, it could be due to a damaged on/off switch or cord. Replace any damaged parts before using the sander.
How to fix a RIDGID Sander that won't turn on?
If your RIDGID Sander's motor will not run, it could be due to a damaged on/off switch or cord. Replace any damaged parts before using the sander.
What to do if my RIDGID Sander keeps tripping the circuit breaker?
If your RIDGID Sander frequently blows a fuse or trips a circuit breaker, there are several potential causes. It could be that the motor is overloaded, so try feeding the workpiece slower. Another reason may be incorrect fuses or circuit breakers in the power line, so install the correct ones. Finally, the relay might not be operating correctly; in this case, have it replaced.
Why does my RIDGID Sander motor lack power?
If your RIDGID Sander's motor fails to develop full power, starts slowly, or doesn't reach full speed, the issue could stem from a few sources. First, the circuit might be overloaded with lights, appliances, and other motors, so avoid using the sander on heavily loaded circuits. Second, there might be a general overload of power company facilities; in this case, request a voltage check by a qualified electrician. Lastly, the motor relay might not be operating properly, so have the relay replaced.
What to do if my RIDGID EB44241 Sander stalls?
If your RIDGID Sander's motor stalls, leading to blown fuses or tripped circuit breakers, it could be due to several reasons. The motor relay might not be operating correctly, in which case you should have the relay replaced. Another cause could be voltage that's too low, due to a circuit overload or general overloading of power company facilities; request a voltage check by a qualified electrician. Finally, incorrect fuses or circuit breakers in the power line could be the culprit; install the correct fuse or circuit breaker.
Why is my RIDGID Sander belt slipping?
If the sanding drum or belt on your RIDGID sander slips or slows down easily, it may be because you're applying too much pressure to the workpiece; reduce the pressure. Alternatively, the spindle knob might be too loose; tighten it.
Why is my RIDGID EB44241 overheating?
If the motor of your RIDGID sander overheats, it's possible that the motor is overloaded. Try reducing the pressure on the workpiece.
Why does my RIDGID Sander burn the wood?
If wood burns while using your RIDGID Sander, it's likely that the sanding drum is glazed with sap. Replace the sandpaper.
Why isn't my RIDGID EB44241 removing material?
If the sandpaper on your RIDGID Sander isn’t removing material, it’s likely compacted with sawdust. Replace the sandpaper.
Why doesn't my RIDGID Sander spindle move fully?
If the spindle on your RIDGID sander doesn’t go through its full 3/4” travel, it could be due to a few reasons. First, sawdust might be compacted under the lower drum washer. Vacuum the sawdust from that area. Second, the fan might not be installed correctly; ensure that the fan is installed with the vanes facing down.
General
