RIDGID FlexShaft K9-12

Questions and Answers

M
Mr. Richard Miller DDSJul 29, 2025
Why is my RIDGID FlexShaft K9-12 Cleaning Equipment cable kinking or breaking?
- C
  colton13Jul 29, 2025
  The RIDGID Cleaning Equipment's cable may kink or break, or the FlexShaft Machine might wobble due to several reasons. It may be because the cable assembly is being forced, so avoid forcing it. Also, ensure you're using the correct FlexShaft Machine or chain knocker for the pipe diameter. Use reverse only if the flex shaft gets caught in the pipe. Routine cleaning of the cable assembly is important if it's been exposed to acid or is corroded. If the cable or sheath is worn out, replace the cable assembly. Supporting the cable assembly properly and correctly setting up/adjusting the chain knocker are also important. Make sure you choose the proper drill and place the equipment on a level, stable surface.
W
woodcoreyAug 6, 2025
How to prevent cable kinking on RIDGID FlexShaft K9-12?
- W
  weeksmarkAug 6, 2025
  The RIDGID Cleaning Equipment's cable may kink or break, or the FlexShaft Machine might wobble because the cable assembly is being forced. Do not force cable assembly.
A
Alexis PattersonAug 13, 2025
When to use reverse on RIDGID FlexShaft K9-12 Cleaning Equipment drill?
- C
  Cristian HenryAug 13, 2025
  The RIDGID Cleaning Equipment's cable may kink or break, or the FlexShaft Machine might wobble because the drill is being run in reverse. Use reverse only if the flex shaft gets caught in pipe.
D
dawncooperAug 21, 2025
What if RIDGID Cleaning Equipment is not level?
- S
  Steven RoachAug 21, 2025
  The RIDGID Cleaning Equipment's cable may kink or break, or the FlexShaft Machine might wobble because the ground is not level. Place the equipment on a level stable surface.