What to do if FlexShaft Machine wobbles or moves while cleaning drain with RIDGID FlexShaft K9-306?
If the FlexShaft Machine wobbles or moves while you're cleaning a drain with your RIDGID Cleaning Equipment, make sure you are operating it in a clear, level, and stable location.
How to prevent RIDGID FlexShaft K9-306 Cleaning Equipment cable kinking?
To prevent cable kinking or breaking in your RIDGID Cleaning Equipment, avoid forcing the cable assembly, and always follow the operating instructions. Make sure you're using the correct FlexShaft Machine or chain knocker for the pipe size. Regularly clean the cable assembly and replace it when it's worn. Ensure the cable assembly is properly supported and that the chain knocker is correctly set up and adjusted. If issues persist, it may be necessary to have the switch or cord replaced, or to take the equipment in for service. Operate in a clear, level, and stable location. If the issue is electrical, try resetting the GFCI or Thermal Overload.
What to do if motor does not turn on with switch on RIDGID FlexShaft K9-306?
If the motor on your RIDGID Cleaning Equipment doesn't turn on with the switch, there could be a few reasons. It might be due to a faulty REV/O-OFF/FOR switch, in which case you should have the switch replaced. Alternatively, the power cord could be damaged, requiring a cord replacement. In the worst-case scenario, there could be a short circuit in the motor, which means you should take it in for service.
Why is the cable kinking or breaking on my RIDGID FlexShaft K9-306?
Cable kinking or breaking in your RIDGID Cleaning Equipment can occur if the cable assembly is being forced. To prevent this, avoid forcing the cable assembly and follow the operating instructions.
What to do if cable assembly exposed to acid or corroded on RIDGID FlexShaft K9-306 Cleaning Equipment?
If the cable assembly of your RIDGID Cleaning Equipment is exposed to acid or corroded, it's likely that the cable or sheath is worn out. In this case, you should replace the worn cable assembly.
Why does the cable turn in one direction but not the other on RIDGID FlexShaft K9-306?
If the cable on your RIDGID Cleaning Equipment turns in one direction but not the other, it could be due to using an incorrect FlexShaft Machine or chain knocker for the pipe diameter. Ensure you are using the correct FlexShaft Machine or chain knocker for the pipe size.
General| Brand | RIDGID |
|---|---|
| Model | FlexShaft K9-306 |
| Category | Cleaning Equipment |
| Language | English |
Explains signal words and symbols used in the manual and on the product for clarity.
Comprehensive safety warnings for power tools, work areas, and personal protection.
Critical safety precautions specific to the FlexShaft drain cleaning machine operation.
Steps to inspect the machine before use to ensure safety and proper function.
Instructions for safely and effectively operating the drain cleaning machine.
Solutions for common problems encountered with the drain cleaning machine.
To Next Page
