What to do if my RIDGID K-750 Cleaning Equipment machine wobbles while cleaning a drain?
If your RIDGID Cleaning Equipment wobbles or moves while cleaning a drain, there are a couple of potential causes: * The kickstands may not be on the ground. Move the kickstands to the use position. * The ground may not be level or stable. Place the equipment on a level, stable surface.
What to do if my RIDGID K-750 Cleaning Equipment AUTOFEED doesn’t work?
If the AUTOFEED on your RIDGID Cleaning Equipment isn't working, there are several potential causes and solutions: * The AUTOFEED may be full of debris. Try cleaning it. * The AUTOFEED may need lubrication. Try lubricating it. * The AUTOFEED may not be set properly for the cable size. Ensure it is properly set according to the instructions. * The cable may not be evenly distributed. Pull all the cable out and refeed it in, making sure to distribute it evenly.
Why does my RIDGID Cleaning Equipment cable keep kinking or breaking?
The cable on your RIDGID Cleaning Equipment might be kinking or breaking because it is being forced. To prevent this, do not force the cable; let the cutter do the work.
What to do if the Ground Fault Circuit Interrupter trips when using my RIDGID Cleaning Equipment?
If the Ground Fault Circuit Interrupter (GFCI) trips when your RIDGID Cleaning Equipment is plugged in or when the foot pedal is depressed, it may be due to a faulty GFCI. Replace the cord set, which includes the Ground Fault Circuit Interrupter.
What to do if my RIDGID Cleaning Equipment motor is turning but the drum is not?
If the motor of your RIDGID Cleaning Equipment is turning but the drum isn't, the belt may be slipping because the cable is being forced. Try re-installing the belt.
Why does my RIDGID K-750 drum turn in only one direction?
If the drum on your RIDGID Cleaning Equipment turns in only one direction, the motor may be switched to reverse. Use reverse only if the cable gets caught in the pipe.
General| Power Source | Electric |
|---|---|
| Voltage | 115 V |
| Cable Diameter | 5/8 in. (16 mm) |
| Motor | 3/4 HP |
| Weight | 83 lbs. (38 kg) |
| Drain Line Capacity | 3 - 6 in |
| Dimensions | 21 in. L x 20 in. W x 41 in. H |
To Next Page
