62
Bolero 2.0 User Manual
3.4.12 Walk-Test
The Walk-Tests (Pro) lets the user analyze the signal quality to the visible Antennas.
This function is started in the Beltpack Menu 'Service > Test > Walk Test (Pro)'.
New in 2.0
While walking through the Beltpacks' operation area, the display shows the current radio levels of all visible Antennas.
The active Antenna is highlighted. When using the Walk Test or Walk Test Pro screens on a Beltpack, the normal keys
(1-6) and both rotaries retain the same functionality as on the Main View. That means calls can be initiated or stopped
by pressing the keys, volumes can be changed using the rotaries, etc., with the screen showing the Walk Test or Walk
Test Pro data all the while. The only exception is the Reply key, which is used to exit the Walk Test or Walk Test Pro
screens and thus does not have the same function as on the Main View.
Unique number defined in DECT for the Antenna.
Average number of receive signal strength. The value may vary due to fading.
Shows if the Antenna is full occupied by Beltpacks.
Average number of detected errors in the link from the Antenna to the Beltpack (e.g. sync error
or CRC).
Average number of detected errors in the link from Beltpack to Antenna.
Phase difference from the Antenna, the Beltpack is connected to, and a secondary Antenna. This
number has to be below ±2. If it is outside this range, the clock in the network is not in sync. In
this case, handover will not be possible as the Beltpack cannot see other Antennas anymore. The
Beltpack clock is always synchronized to the clock of the connected Antenna.
To Next Page
Loading...
Need help?
General