Riedel Bolero 2.0 User Manual

63
Bolero 2.0 User Manual
3.4.13 Reset
The Beltpack-Menu 'Service > Reset' offers two different ways to reset the Beltpack to factory default settings.
Figure 99: Beltpack menu – Reset
Profile Defaults
This resets the Beltpacks' Profile data the current default settings of the net.
All registration data stays in memory.
Factory Reset
This resets all data and settings to factory default.
All Net lists and registrations data will be deleted.
3.4.14 Opening the USB rubber cover
The USB rubber cover yields protection against ingressing dirt and water inside the Beltpack.
The rubber cover can be removed as follows:
· Turn the Beltpack's rear side upwards.
· Push your fingernail gently in the slit on the top of the rubber cover...
· and pull the rubber cover out of the Beltpack's connectors.
· Take care to seal the Beltpack when the connectors are not in use.
Figure 100: Insert fingernail
Figure 101: Pull rubber cover

Riedel Bolero 2.0 Specifications

General

Brand	Riedel
Model	Bolero 2.0
Category	Battery Charger
Language	English