Riello 40 F10 - Electrical Wiring

2094
5
GB
ELECTRICAL WIRING
Brown
White
(50V)
Blue
Motor
Capacitor
Regulating thermostat
Neutral
Main switch
T6A
N L
M
~
S7029
Black
NOTES
– Wires of 1,5 mm
2
section.
– The electrical wiring carried out by the installer
must be in compliance with the rules in force in
the Country.
– To remove the control-box from the burner,
loosen screw (A) (see figure) and pull
towards the arrow.
– The photoresistance is fitted directly into the con-
trol-box (underneath the ignition-transformer) on
a plug-in support.
TESTING
Check the shut-down of the burner by opening
the thermostats.
CARRIED-OUT IN THE FACTORY
WARNING
DO NOT EXCHANGE THE
230V ~ 50Hz
NL
Limit thermostat
with manual resetting
Remote lock-out lamp
(230V - 0.5A max.), if required
123456789
Blue
Brown
Terminal block of
control-box 530SE
*
Valve
T
T
RUN OF THE ELECTRICAL CABLE
1 - Grommet N - Neutral
2 - Cable-clamp L - Phase
3 - Terminal block - Burner-earth
D5228
Black
NEUTRAL WITH THE PHASE