Need help?Do you have a question about the Riello G3 and is the answer not in the manual?
General| Model | G3 |
|---|---|
| Control | Electronic |
| Frequency | 50/60 Hz |
| Type | Burner |
| Stages | Single Stage |
| Voltage | 220-240V |
Details the purpose, importance, and handling of the instruction manual for the burner.
Outlines procedures for system delivery and user information about the manual's content.
Explains recommended periodic checks for pump pressure operation and filter cleaning.
Illustrates the operational range of pressure vs. thermal power and oil output.
Provides physical dimensions for the flange and the burner unit.
Details correct placement of the insulating gasket and burner flange for installation.
Instructions on how to prime the pump for initial startup and fuel flow.
Describes how to check burner shutdown by opening the thermostats.
Lists recommended nozzle types and their angle for optimal output and flame stability.
Explains factory pressure settings and adjustments for low-temperature ignition.
Details how to set the combustion head position based on burner output.
Instructions for adjusting the air damper to control airflow for optimal combustion.
Illustrates normal and lock-out sequences during burner startup and light failure.
Describes how to position the burner using a pin and nut for maintenance access.
Provides specific dimensions for electrode placement to ensure proper ignition stability.
Recommends specific types of atomizing cones for optimal fuel spray.
Explains factory pump pressure and adjustment for low oil temperatures.
Guides on adjusting the combustion head beyond standard settings for stability.
Advises on adjusting the air damper for minimal excess air and optimal combustion.
To Next Page
