To Next PageTo Next Page
Need help?Do you have a question about the Riello GS20 and is the answer not in the manual?
General| Voltage | 230 V |
|---|---|
| Air Regulation | Mechanical |
| Protection Rating | IP40 |
| Frequency | 50 Hz |
| Stages | Single-stage |
| Burner Type | Gas Burner |
| Control | Electronic |
Lists the components included with the burner.
Provides specific technical data for the burner, including power, supply, and dimensions.
Shows the physical dimensions of the burner and flange for installation planning.
Illustrates the relationship between gas pressure and burner output for performance tuning.
Details how to fix the burner to the boiler, including thickness limits and extensions.
Explains the correct positioning of the probe and electrode for optimal function.
Illustrates the gas supply line components and required connections.
Provides a diagram and instructions for the correct electrical wiring of the burner.
Describes how to route and secure electrical wires using cable clamps.
Details how to adjust the combustion head for optimal performance.
Explains how to adjust the air damper for air-rate regulation.
Information on checking combustion parameters like CO2 and CO levels.
Describes the normal sequence of operations during burner start-up.
Information on interpreting LED signals during start-up for fault diagnosis.
Explains how to reset the control box and utilize diagnostic functions for troubleshooting.
Details signal codes (blinks) and their associated problems and recommended remedies for start-up failures.
Lists flame detection times corresponding to LED signals for performance monitoring.
