Riello RLS 70 - LED Status During Normal Operation and Check Mode

20168481
42
GB
LED indicator and special function
8.4 LED lamps: burner operating status
OPERATING STATUSES INDICATED BY LEDS DURING NORMAL OPERATION AND CHECK MODE
Tab. Q
1. LEDs form a progress bar which indicates the Flame Signal
Power in order to orientate the sensors during commissioning
(LEDs “Grow” upwards, moving away from the Status at 20%
intervals of flame power.)
2. LEDs indicate the error or lock-out code for troubleshooting.
3. LEDs change from ON to BLINKING to OFF showing the
servomotor movement control until the position-reached
feedback is received see paragraph “Problems - Causes -
Remedies signalled by LED indicators” on page 43“.
Operation
LED ● = ON
Fan
Damper
open
Damper
closed
Modulation Ignition Flame Status
Icon
Power OFF/ON OFF
Not ready/
Diagnostics
Green
Standby ● Green
Servomotor
movement
(Note 3)
●
OFF
Flashing
●
●
Flashing
OFF
Green
Waiting for closing Green
blinking
Green
OPEN
(before ignition)
● ● Green
Minimum
(before ignition)
● ● Green
Ignition ● ● ● Green
PTFI
● ● ●
Green
blinking
Green
MTFI ● ● ● Green
Active modulation ● ● ● Green
Minimum output
position
● ● ● Green
With flame present ● ● ● Green
Economy mode ● ● Green
Check during maximum
opening phase
Flashing ● Yellow
Check during minimum
closing phase
Flashing ● Yellow
Check during ignition
phase with pilot PTFI
Flashing ● Note 1 ● Note 1 ● Note 1 ● Note 1 ● Note 1 Yellow
Check during ignition
phase with main fuel
valve MTFI
Flashing ● Note 1 ● Note 1 ● Note 1 ● Note 1 ● Note 1 Yellow
Fault/lock-out ● Note 2 ● Note 2 ● Note 2 ● Note 2 ● Note 2 ● Note 2 Red
End of the cycle ● ● ● Green
S9740
S9741
S9742
S9743
S9744
S9745
S9746