To Next PageTo Next Page
Need help?Do you have a question about the Riello VOKERA VISION PLUS 30C and is the answer not in the manual?
General| Boiler Type | Combi |
|---|---|
| Fuel Type | Gas |
| Mounting | Wall Mounted |
| ERP Rating | A |
| DHW Output (kW) | 30 |
| Warranty | 5 years |
| Modulation | 1:5 |
| Flow Rate (l/min) | 12 l/min |
| Dimensions (H x W x D) | 420mm |
| Fuel | Natural Gas |
Describes the different operating modes: Winter, Summer, and Off.
List and description of error codes and their alarm types.
Explains the boiler's operation at rest, during heating, and during hot water demand.
Details the safety features integrated into the boiler for secure operation.
Technical data for central heating and domestic hot water functions.
Detailed energy efficiency data for the Vision Plus 25C model.
Detailed energy efficiency data for the Vision Plus 30C model.
Requirements for gas supply, flue system, and air supply for the appliance.
Details on electrical supply requirements and mounting on combustible surfaces.
Requirements for gas, flue, and air supply in EIRE.
Electrical supply and mounting guidelines for EIRE.
Steps for preparing the mounting location and wall bracket.
Instructions for installing concentric and telescopic horizontal flue kits.
Procedure for fitting the rear flue outlet and terminal.
Guidelines for extending the flue system and ensuring correct connections.
Instructions for fitting the concentric vertical flue system.
Procedure for connecting gas, cold water inlet, and hot water outlet.
Details on condensate pipework and electrical connections.
Instructions for connecting the 230V mains electrical supply.
Steps to access and navigate the boiler's parameter menus.
Explanation of the control panel display, icons, and button functions.
Configuration parameters related to hydraulic setup, water pressure, and air purging.
Parameters for adjusting heating system settings like hysteresis and anti-cycle.
Steps to follow before supplying power and starting the boiler.
Detailed description of parameters within the P3 configuration menu.
Detailed description of parameters within the P4 heating menu.
Further details on P4 heating parameters like weather compensation and night settings.
Procedure for initial commissioning of the boiler.
Details on switching between Winter, Summer, and Off modes.
Setting heating temperature without an outdoor temperature sensor.
Steps for initial lighting, checking gas pressure, and combustion analysis.
Steps and checks to be performed during routine annual servicing.
General procedure for component removal and replacement.
Procedure for checking the gas valve and performing combustion analysis.
Procedure for calibrating the gas valve based on CO2 readings.
Comprehensive list of boiler fault codes, faults, and alarm types.
Steps for converting the boiler from natural gas to LPG.
Flowchart guiding the CO and combustion ratio check process.
Requirements for completing the Benchmark commissioning and warranty validation service record.
