RIESE & MULLER VBK0133 - Mounting the Front Carrier; Prepare Steerer and Remove Components; Install Carrier and Stem Assembly

Riese & Müller GmbH | Feldstraße 16 | D-64331 Weiterstadt | Tel.: 06151-366 86-0 | Fax: 06151-366 86-20 | E-Mail: team@r-m.de | Internet: www.r-m.de
Page 4 of 6
Datei: VBK0133-Frontgepäckträger-160624.docx
Stand: 20.02.2017 14:54:00
ENGLISH: Assembly Instruction Dealer
Cruiser/Swing/Wave FRONT CARRIER (VBK0133)
Cruiser/Swing/Wave FRONT CARRIER (VBK0133)
These Riese & Müller E-bikes can be retrofitted with the front carrier:
 Swing
 Cruiser und Cruiser Mixte (not permitted at fast E-bikes!)
 Wave
This manual consists of two parts (assembly instruction and manual).
Hand the manual over to the customer.
Scope of delivery
 1x front carrier
 1x light bracket for front carrier
 1x light bracket 1 1/8“
 1x upper seal cap, flat
 1x rounded head bolt (allen M 6 x 20 mm ISO 7380 A2)
 1x selflock nut (high DIN 982 A2)
 2x washer (d = 6,4 mm DIN 125 A2)
 2x bolt (allen M 5 x 16 mm DIN 912 A2)
 2x countersunk screw (Torx M 5 x 20 mm ISO 965 A2)
 2x cap nut (M5 DIN 917 A2)
 2x washer (d = 5,3 mm DIN 125 A2)
 3x zip-tie
Mounting the front carrier
1. Remove handlebar stem and all aheadset spacers from steerer (see fig. 1).
2. At model Wave: replace conical seal cap by flat seal cap (see fig. 2).
fig. 1: steerer with removed stem
fig. 2: flat seal cap at Wave
3. Dismantle the frontlight.
4. Place front carrier at steerer. Install and adjust handlebar stem and adjust headset bearing.