15
Shackmaster™ Power 500 DC Power Supply Instruction Manual
Operation
Powering Device Up
Once you have completed all the preparations, you can turn the Main Switch on the
rear panel to position “I”. After that, the device will go into Standby Mode turning on
the screen for a short time to show the Device Serial Number.
By default, the device is configured to be Switched On / Off by a Swipe gesture or a
Long Press gesture.
Later, you can change these and other settings yourself using the REAMP
companion software.
To Turn device ON quickly use a Long-Press gesture.
To Turn device OFF quickly, also use a Long-Press gesture.
A swipe is done when you touch and
slide your finger across the screen.
You can swipe quickly or slowly.
The device distinguishes between
swiping up, down, left and right.
A long press (press-and-hold) is done when you touch the screen
and hold your finger on the same spot. This gesture is also called
«press and hold» and can be used to activate special menus or
switch power supply off/on quickly.
To Next Page