12
Shackmaster™ Power 500 DC Power Supply Instruction Manual
First Power-Up
Before you perform the first power-up, make sure your setup complies with the safety
requirements outlined below.
General safety precautions below must be followed in each phase of the power supply
operation. In case of failure to follow these precautions or specific warnings in other
parts of the manual is considered as violation of the safety standards related to the
design, manufacture and intended use of the instrument. If the user does not follow
these precautions, the Manufacturer will be held not responsible for any consequences.
WARNING
The Power 500 can only be used indoors or in low condensation areas.
The general environmental requirements are stated in the Specifications section.
To avoid accidental injury, the power cord supplied by the manufacturer only
must be used.
The Power Supply is provided with a three-core power cord that should be
connected to a three-core outlet which is properly grounded. Before operation,
make sure that the Power 500 is well grounded.
Use electric wires of appropriate load. All loading wires should be capable
of bearing maximum short-circuit of electronic load without overheating.
To Next Page