19
Shackmaster™ Power 500 DC Power Supply Instruction Manual
Service Functions
The power supply has an interface with a computer, that provides you with additional
capabilities of device control and its condition monitoring, namely:
The RigExpert
©
REAMP Logger software enables you to control the Power 500 power
supply remotely via USB interface. This instrument enables you to record all
aspects of the operation of the Power 500 supply over a long period of time and
subsequently analyze the accumulated data subsequently.
To get software please use link
https://rigexpert.com/products/reamp-logger/reampsw/
The setup program installs the REAMP Logger software on PC’s running Windows,
MacOS and Ubuntu 21.10 operation systems.
To install the software, download the latest software installer from the REAMP Logger
product homepage https://rigexpert.com/products/reamp-logger/reampsw/
The following automatic functions can be controlled by the software:
automatic power-off if inactivity is longer then determined of inactivity;
automatic ON/OF switching at the determined time set;
automatic switching back ON in case of mains failure.
The RigExpert REAMP software can be used to adjust and tune the display.
The special companion PC software to log consumption and auxiliary data both for
USB and Anderson Powerpole
®
Connectors during the operation of the power supply.
USB interface to log consumption data and update firmware.
Installing REAMP Logger software
To Next Page
Loading...