Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-77
the Pinyin input area. After inputting the Pinyin for a Chinese character, tap
the desired Chinese character in the Chinese character display area (if no
proper Chinese character exists, tap or to page down to search for
the desired Chinese character). The selected Chinese character will be
displayed in the filename input area. Use the same method to input all the
Chinese characters of the filename. You can also tap the delete the
unwanted characters in the Pinyin input area, and then delete the Chinese
character located ahead of the cursor in the filename input area.
4. To Save a File
After finishing inputting filename in the filename input interface, press "Ok", and
the generator will save the file with the specified filename to the currently
selected directory. Tap "Cancel" to cancel the save operation.
Read
1. To Select the Read Path
Selects Disk C or D (when inserted with a USB storage device) as the current
read path.
You can tap Disk C or D to enter the current directory. You can also use the Left
arrow key to locate the cursor to the left side of the user interface, and then
rotate the knob to select Disk C or D. Press down the knob to enter the current
directory.
2. To Select the File to be Read
In the selected path, tap or use the knob to select the file to be read.
For Disk C, only state file and arb file can be read. For Disk D, the state files, arb
waveform files, Csv files, and bitmap files can be read. Note: the bitmap file can
only be read when you self-define splash screen.
3. Read a file
Press Read, and the generator will read the currently selected file and display
the corresponding prompt message when the file is read successfully.
Copy and Paste
1. To Select a File to be Copied
In the selected path, tap or use the knob to select the file to be copied.
2. To Copy a File
Tap Copy, the generator will copy the currently selected file.
3. To Select a Paste Location
To Next Page
Loading...
