Chapter 3 Remote Control RIGOL
DG800 User's Guide 3-5
(b)
If the resource cannot be searched automatically:
Select the GPIB card address of the PC from the drop-down box of
"GPIB0::" and select the GPIB address set in the signal generator from the
drop-down box of "0::INSTR".
Click "Test" to check whether the GPIB communication works normally. If
not, please follow the corresponding prompt messages to solve the
problem.
5. View the device resource
Click to go back to the main interface of Ultra Sigma. The GPIB
resources found will appear under the "RIGOL Online Resource" directory.
For example, DG832 (GPIB0::16::INSTR).
6. Communication test
Right-click the resource name "DG832 (GPIB0::16::INSTR)", and select "SCPI
Panel Control" to open the remote command control panel. Then you can send
commands and read data through the panel.
To Next Page
Loading...
